Copper rope breeding method

First, soil

Copper coil is more prone to raise, it is not high for soil, even if the soil is slightly poor, it can grow. However, copper moisture is a non-drought-resistant plant. Based on this, it requires the soil that is loose, breathable, and good drainage. The breeding copper coil soil is a key, and the suitable soil is conducive to the growth of copper coil, and the phenomenon of death of copper rolls will die.

Second, light and temperature

Copper coil can accept half-sunshine, more infinity, but avoid direct sunlight, so it can be maintained in a half-yin environment, but cannot be too shaded. Insufficient light, it will make copper roller leaves rot, so we must ensure that the light time of 4 to 6 hours will be guaranteed daily, which is conducive to the growth of Copper.

Copper millet is not resistant to high temperatures, it requires a relatively warm growth environment, typically grows well between 10 ~ 25 ° C, the summer temperature does not exceed 32 ° C, and the winter winter temperature should not be less than 5 ° C.

Third, watering and fertilization

Copper rigging is relatively high for water, it likes to wet some environment. In the summer, the temperature is high, the vanes of copper ruts are much easier, so much water is made in summer. It is often watering water to the plant, and the air humidity can be improved, and the effect of cooling is, and the blade of the copper river can be cleaned, which is convenient for photosynthesis. The temperature in winter is low, and the copper moisture requires the potting soil to be biased as good, Ningqiu Do not wet, and there should be no water in the basin.

When the copper coil is watering, it is generally poured every half a month, keeps the pot soil moist. If it is a water-raised copper river, you have to change water every 7 to 10 days in spring and summer, and the autumn will change the water every half a month. Under normal circumstances, the northern tap water needs to stand in the sun or the cool place for 1 to 2 days.

Copper rigging is relatively large, and in the growth of copper riches, you can topose every 2 to 3 weeks. Fertilizers can be determined according to the size of the growth vessel of copper river, and the container is small, and the amount of fertilization can be appropriately reduced, so as not to cause fat.

Fourth, pay attention

1, flower pot selection. When the copper coil is selected, it is necessary to determine according to the plants of copper rough grass. Generally speaking, copper roller does not need a lot of pots, and you can use a big bowl or use the water fairyna. Copper rigs can basically cover the root stems when planting, don’t be buried too deep. After planting the copper dragonfly planted, it is planted in the half-yin, and the maintenance can be exposed to the sun.

2, trim. Copper coil is rarely needed, but if the leaves of the copper grass are over dense, or the leaves are yellowing, they need to trim, remove the yellow leaves and excess leaves. In the spring, the copper rose can be changed in the basin, and the trimming is carried out and rancunds. It is, it can also be plasticized to copper roughing while changing the pot. The plants of glare copper grass are too high, and there is a long situation, and the high fat of copper ruts should be cut off, making it new branches.

Leave a Reply