How to breed the antlers and begonia

How to breed

Appropriate cutting matrix

The breeding of the antlers and begonia is mainly cuttings. The matrix of cuttings requires good performance. Not only does it require good drainage function and breathability, but also has good function to maintain water and air. For example, perlite, grassy carbon, vermiculite, furnace ash, etc. can be used with each other. However, it must be disinfected before use. At the same time, it is necessary to lay an appropriate amount of plant materials rich in corrosive nutrients. The bottom of the matrix is ​​best to use large granules to laid the drainage layer.

Keep air humidity

After cutting, it is necessary to avoid the sudden decrease in the relative humidity of the air. It is best to keep more than 70%, especially before rooting, it is recommended to maintain the relative humidity of the air at 90%.

Appropriate light

After cutting the antlers and begonia, the light should not be too much or too much, otherwise it will affect the growth of the irregularities and the lack of supply of nutrients. It is best to put it in a relatively cool place and have astigmatism. Do not be completely dark.

Appropriate temperature

The most suitable temperature of the antlers Begonia cutting is between 20 and 35 degrees, which can reduce the harm caused by rotten bacteria during this period. And the temperature changes in the morning and evening are more easy to take root than at the constant temperature.

Maintenance management

The protective details of the antlers after cuttings, summarizing the above, is to choose the right temperature and matrix to maintain higher air relative humidity, and avoid direct sunlight. Once a fungus appears in the matrix, spray the sterilization agent in time. Everyone should remember, do not move and touch it because of anxiety.

Leave a Reply